AD11 XP motherboard requires a reset to boot. What gives?

FAQ

Profile

AD11 XP motherboard requires a reset to boot. What gives?

Hardware Problem Solving Community! (Home) -> FIC

Next: k6 III+450 on V-503A

Author

Message

smread_bogus_

External

Since: Sep 09, 2003
Posts: 1

(Msg. 1) Posted: Wed Sep 10, 2003 1:05 am Post subject: AD11 XP motherboard requires a reset to boot. What gives? Archived from groups: alt>comp>periphs>mainboard>fic (more info?)

I've had this FIC AD11 XP motherboard for about 6 months with an AMD Athlon 1600+ XP chip on it and it never boots by itself. After pressing the power button, I have to press the reset button to get the board to start booting. Not even the initial video card signon until the reset is pressed. I've had more than one video card (agp) in the system and it makes no difference. Seems like I've tried most all BIOS settings that I thought would get this fixed, but not to any avail. Anyone know what's going on here? >> Stay informed about: AD11 XP motherboard requires a reset to boot. What gives?

Display posts from previous:

Related Topics:

AD11 will not take ABA46 Bios - Followed all the directions for flashing bios and nothing happens from A: prompt. Computer runs fine for day or two with Windows XP then it won't even start in SAFE MODE? Replaced HD & Ribbon cord, video card, shut down DVD and burner and floppy dr...

Clock gets reset with enabled RTC alarm resume - About 5 years I have been using my VA503+ without any problems. Now the PC with that board will be used as digital video recorder (Linux VDR). Therefore I enabled the RTC alarm resume first time - an got problems: The system clock gets reset frequently.....

AU13 doesn't boot.... - I bought a couple AU13s from fry's and can't get them to show the boot up screen. I have tried exchanging every component, memory, processor, power supply, video card, monitor, etc... My setup is as follows : Processor+Heatsink, 512M DDR mem, ATX 350...

AU13 boot problems - Hi everyone; In an attempt to solve what appeared to be a failing motherboard, I replaced my old ASUS KT7 motherboard with a FIC AU13 with a 2600mHz AMD cpu. I replaced the power supply because my old one did not have the 4 pin 12V connector that the..

Installed Realtek, now have boot problem - Installed the Realtek NIC on my FIC 503+. At first win98SE would not load. Thought maybe it was due to IRQ assignment. It looked as if many devices were assigned to 03. Changed the BIOs and it picked up the NIC from 03 to 10 and the video from 03 to 09...

	Hardware Problem Solving Community! (Home) -> FIC	All times are: Pacific Time (US & Canada) (change)
Page 1 of 1

You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum