Boot Drive Problem

Hi all,

I just finished putting together a system based on a GA-7VAXP board
and upon powering up everything appeared to be fine.

All drives recognized, memory counted, then a search for drives
attached to the RAID ports IDE3 & 4, which there are none attached but
finally it gets to "verifying DMI pool data" and then "boot from CD"
and then DISK BOOT FAILURE, INSERT SYSTEM DISK AND TRY AGAIN".

I have gone into the BIOS over and over and set the 1rst boot device
to floppy and it still wants to boot off of the CD drive.

I have reset to default values, checked the floppy cables which appear
to be good as once I set "seek floppy at bootup" and it did.

I want to run the hard drive setup utilities on floppy, I guess I
could copy them from floppy to CD but, I want to work this out and
have the machine boot to the drive I tell it to.

Scratchin my punkin head over this one......

Ken

REV 1.2 BIOS F11