DFI's NFII Ultra motherboard - how to reset the BIOS

HELP!
I purchased the LANPARTY NFII ULTRA , had the motherboard installed
and running fine.
I tried to overclock it just to bump up the performance, but it will
not boot up?
all four LED are on, it sounds like it's booting, but my monitor says
"No signal input"???
I put the BIOS jumper on pins 2 & 3 as the book shows - but the BIOS will
not reset.
I tried it with the jumper on for 3 minutes, with the power cord
connected and
I tried it for 3 minutes with the power cord NOT connected.
HELP?!?!?
any help would be appreciated.

If I push the reset button during the BIOS loading sequence, it resets all
of my overclocking scenarios. If I push mine too far it does the same thing,
then when I hit reset it resets my computer back to a 133 bus and DDR400.
Try turning on your computer and about 5 seconds after push reset.
-- MiniDisc_2k2
To reply, replace nospam.com with cox dot net.

"calban" <calban.RemoveThis@mail.com> wrote in message
news:58cf5ca9.0307030800.2004e0f8@posting.google.com...
 > HELP!
 > I purchased the LANPARTY NFII ULTRA , had the motherboard installed
 > and running fine.
 > I tried to overclock it just to bump up the performance, but it will
 > not boot up?
 > all four LED are on, it sounds like it's booting, but my monitor says
 > "No signal input"???
 > I put the BIOS jumper on pins 2 & 3 as the book shows - but the BIOS will
 > not reset.
 > I tried it with the jumper on for 3 minutes, with the power cord
 > connected and
 > I tried it for 3 minutes with the power cord NOT connected.
 > HELP?!?!?
 > any help would be appreciated.<!-- ~MESSAGE_AFTER~ -->