cannot boot from SATA DVDROM

Hi

I have 2 SATA HDDs set in RAID1 and 1 SATA DVD drive connected to Abit
AA8XE. Everything works -- except I cannot boot from CD/DVD at
startup. My BIOS options are:

OnChip IDE Device:
IDE Bus Master: Enabled
OnChip IDE-1 Controller: Enabled
SATA Mode: RAID
all the following options are not editable:
On-Chip Serial ATA: Enhanced Mode
PATA IDE Mode: Primary
SATA Port: SATA2,SATA4 is Sec.
IDE Channel 0 Master: IDE Master
IDE Channel 0 Slave: IDE Slave
IDE Channel 1 Master: None
IDE Channel 1 Slave: None
IDE Channel 2 Master: SATA1
IDE Channel 2 Slave: SATA3
IDE Channel 3 Master: SATA2
IDE Channel 3 Slave: SATA4


After POST, Intel Application Accelerator RAID Option ROM shows:
RAID Volumes:
ID=0
Name=RAID_Volume0
Level=RAID1(Mirror)
Strip=N/A
Status=Normal

Physical Disks:
Port=0 Drive=WDC ... Type=Member Disk(0)
Port=1 Drive=WDC ... Type=Member Disk(0)


I cannot find any option to change SATA ports booting order.

On Wed, 24 Oct 2007 13:06:42 -0700, bbla32.DeleteThis@op.pl wrote:

>Hi
>
>I have 2 SATA HDDs set in RAID1 and 1 SATA DVD drive connected to Abit
>AA8XE. Everything works -- except I cannot boot from CD/DVD at
>startup. My BIOS options are:
>
>OnChip IDE Device:
>IDE Bus Master: Enabled
>OnChip IDE-1 Controller: Enabled
>SATA Mode: RAID
>all the following options are not editable:
>On-Chip Serial ATA: Enhanced Mode
>PATA IDE Mode: Primary
>SATA Port: SATA2,SATA4 is Sec.
>IDE Channel 0 Master: IDE Master
>IDE Channel 0 Slave: IDE Slave
>IDE Channel 1 Master: None
>IDE Channel 1 Slave: None
>IDE Channel 2 Master: SATA1
>IDE Channel 2 Slave: SATA3
>IDE Channel 3 Master: SATA2
>IDE Channel 3 Slave: SATA4
>
>
>After POST, Intel Application Accelerator RAID Option ROM shows:
>RAID Volumes:
>ID=0
>Name=RAID_Volume0
>Level=RAID1(Mirror)
>Strip=N/A
>Status=Normal
>
>Physical Disks:
>Port=0 Drive=WDC ... Type=Member Disk(0)
>Port=1 Drive=WDC ... Type=Member Disk(0)
>
>
>I cannot find any option to change SATA ports booting order.

Look under Advanced BIOS Features.